Installation and commission of bag filter dust collector

Before starting the operation, first confirm whether the accessories required for installing the bag filter system are fully prepared, including the following parts: 1 bag filter body 2 type seal ring 3 metal inner net 4 filter bag 5 pressure gauge two ( Optional), and then check the type seal ring and the Ο-shaped groove on the filter machine, please replace the new parts, after the installation, please follow the steps below:

1. Place the bag filter on the station to be filtered, and connect it to the flange of the inlet and outlet or the tube to fix it; suffocate the exhaust port or configure the exhaust valve. Jacket type connection insulation heat source.

2. Gently put the metal inner mesh into the bag filter to make the inner mesh neckline match the bag filter.

3. Place the filter bag so that the ring mouth of the filter bag matches the neckline of the metal inner net.

4. Put the type sealing ring into the Ο-shaped groove, the Ο-type sealing ring can not be twisted or deformed, and the multi-bag filter machine is fastened with the filter bag pressure ring.

5. Hold the handle of the upper cover with one hand and grasp the other end of the upper cover with one hand (the multi-bag filter rotates the top handwheel)

6. After the upper cover is aligned, tighten the two hanging caps at the same time and tighten all the caps one by one (insert the shorts into the rings).

7. Close the exhaust valve installed on the top of the bag filter.

8. Please check whether the connection pipes are firm; whether the working pressure is within the allowable range.

9. Open the output valve. Open the heat source inlet valve, which is the filter temperature rises to the specified temperature.

10. Open the input valve slowly, let the liquid slowly flow in and fill the filter to prevent the liquid from suddenly impacting the filter bag, causing cracking, and then observe whether there is any leakage. If no leaks occur, you can start filtering.