Corrugated belt conveyor (large angle belt conveyor) main features

Corrugated Belt Conveyor (large angle belt conveyor) Main features:

1, high dip angle 2, large output rate 3, no scattering material 4, flexible arrangement
DJ-II corrugated rib belt conveyor (large angle belt conveyor) main parts name and use:

1. Corrugated rib conveyor belt:
Drag and load in the conveyor. Corrugated ribs, diaphragms, and base belts form a “gate” shaped container for conveying material, enabling large angle transmission.
2. Drive device:
It is the power part in the conveyor. It consists of Y series motors, ZJ shaft-mounted speed reducers, and wedge-type backstops.
3. Drive roller:
It is the main component of power transmission, and the conveyor belt runs by its friction with the drive roller. This series of drive rollers has a glue surface and a glossy surface. The glue surface roller is used to increase the adhesion between the roller and the conveyor belt.
4. Change roller:
Used to change the running direction of the conveyor belt. The change roller is used for the lower surface of the conveyor belt (non-load bearing surface).
5. Press belt wheel:
It is used to change the running direction of the conveyor belt, which is used for the upper surface (bearing surface) of the conveyor belt.
6. Roller:
The idler roller is used to support the conveyor belt and the material on the belt so that it can run stably. This series has two types: upper parallel roller and lower flat roller.
7. Support rollers:
The tuck-belt roller is used to support the lower branch of the conveyor belt on the convex arc section frame, which is supported on the empty edges on both sides of the rib conveyor belt. Several sets of belt rollers form an arc segment for redirecting the conveyor belt. Support rollers with cantilever support.
8. Vertical roller:
The vertical roller is used to limit the deviation of the conveyor belt and is installed on the upper and lower excessive section frames. There are four racks on each filter segment, two on each of the upper and lower points.
9. Beat wheel cleaning device:
Used to tap the back of the conveyor belt to shake off the material sticking to the conveyor belt.
10. Tensioning device;
Its role is: 1. The conveyor belt has enough tension to ensure that the conveyor belt and the drive roller does not slip. 2. Limit the sag of the conveyor belt between the supports, so that the conveyor runs normally. This series uses screw tensioning device.
11. Racks, head funnels, head guards, feed chutes, middle racks, intermediate rack legs, etc.:
In the conveyor, it supports, dustproof and guide material respectively. This series of intermediate shelf legs are available in three types: low, medium and high. The lower horizontal section and the incline are only equipped with the low intermediate stand legs, and the upper and lower horizontal sections are respectively equipped with different intermediate stand legs (low and Chinese styles) according to different head frames (low, medium and high head frames). High intermediate stand legs).